Wiring The Tracvision S3 System - KVH Industries TracVision S3 Owner's Manual

Cable Port Assignments
(Exterior of Baseplate)
Interior Baseplate Wiring
2
2.3
The baseplate connectors have been changed to make installation easier.
TracVision S3 Cable Ports
Figure 2-14 shows the antenna unit's exterior baseplate cable
ports, consisting of two RF connectors (ports #1 and #4) and two
liquid-tight fittings (ports #2 and #3). Figure 2-15 shows the
interior baseplate wiring. Refer to these figures when connecting
cables to the antenna unit.
Figure 2-14
Figure 2-15
2.3.1 Wiring the Antenna Data Cable
The data cable now enters the baseplate through the second liquid-tight
fitting (cable port #3). Interior baseplate wiring is unchanged.
Antenna Data Cable-to-Baseplate Terminals Wiring Process
1. Feed the cable up to the roof and through the

Wiring the TracVision S3 System

RF2 Power
(#1) (#2)
Used only with
N. American Systems
Power
Data
RF Cable
second liquid-tight fitting (#3) as pictured in
Figure 2-14.
Data RF1
(#3) (#4)