Mounting The Mcu - KVH Industries TracVision G8 Owner's Manual

TracVision G8 Owner's Manual - Guide to Technical Information
38
2.5

Mounting the MCU

Mount the MCU using either of the following options:
Option 1 - Velcro Fastening on a Horizontal Surface
Option 2 - Flush-mounting
The following sections describe how to mount the MCU for both
of these options.
Option 1 - Velcro Fastening on a Horizontal Surface
1. Choose a location based upon the guidelines in "Choosing
the Best Location for the MCU" on page 25.
2. Remove the four squares of Velcro fabric from the kitpack.
Clean the bottom of the housing with a mild detergent
and water to remove oils, etc. Peel the protective backing
from the squares and apply them to the bottom of the
housing at each of the four corners (see Figure 2-20).
Figure 2-20 Mounting the MCU with Velcro Attachments
Fabric Strips
Hook Disks
3. Position the four Velcro hook disks where the MCU will
be mounted. Drill screw holes for the disks and secure in
place with the #4-24 screws supplied in the kitpack.
4. Press the MCU firmly into place so that the loop material
engages the hook disks.
54-0198