4. Install the new elevation motor with the belt positioned
around the outer lip of the motor hub. Reinstall the
screws and washers that you removed in Step 3, but do
not tighten them yet.
5. Slide the motor until the belt is tight around the motor
hub and elevation pulley. Tighten the screws. Some
readjustment may be necessary if the belt tension results in
excessive vibration.
Figure 5-23 Elevation Belt
Motor Hub
6. Reinstall the shield that you removed in Step 2.
7. Reconnect the motor cable that you removed in Step 1.
54-0198
Elevation Belt
Elevation Pulley
Maintenance
111