KVH Industries TracVision G8 Owner's Manual page 104

TracVision G8 Owner's Manual - Guide to Technical Information
108
Figure 5-17 Azimuth Motor and Belt
#8-32 Locking Nuts (x 4)
4. Install the new azimuth motor with the belt positioned
around the outer lip of the motor hub (see Figure 5-17).
Reinstall the screws and locking nuts that you removed in
Step 3, but do not tighten them yet.
5. Slide the motor until the belt is tight around the motor
hub and azimuth pulley. Then tighten the screws and
locking nuts. Some readjustment may be necessary if the belt
tension results in excessive vibration.
Figure 5-18 Azimuth Belt
6. Reinstall the shield that you removed in Step 2.
7. Reconnect the motor cable that you removed in Step 1.
Azimuth Belt
Motor Hub
Azimuth Belt
Azimuth Pulley
54-0198