Replacing The Lnb/Feed Tube Assembly - KVH Industries TracVision G8 Owner's Manual

TracVision G8 Owner's Manual - Guide to Technical Information
118
5.18 Replacing the LNB/Feed Tube
Assembly
1. Using a 7 ⁄ " wrench, carefully disconnect the RF cables
1 6
from the LNB.
Figure 5-33 LNB (Linear Quad version Shown)
Gyro Cable
Connectors
2. Disconnect the azimuth and elevation gyro cables from
the in-line connectors.
3. Linear quad LNB systems only:
Disconnect the skew motor cable from the PCB module
(see Figure 5-34).
Figure 5-34 Skew Motor Cable Connector on PCB Module
LIMIT SWITCHES AZIMUTH/ROLL GYRO
INTERNAL SENSOR ELEVATION GYRO
#8-32 Screws (x 4)
LNB
RF Cable
Connectors
POWER
FUSE
Cable Connector
Skew
Motor
ELEVATION & AZIMUTH MOTORS
SKEW MOTOR
Skew Motor
54-0198