KVH Industries TracVision G8 Owner's Manual page 110

TracVision G8 Owner's Manual - Guide to Technical Information
114
4. Using a 5 ⁄ " allen key, loosen the two #8-32 set screws
6 4
securing the feed tube in the LNB/feed tube assembly
collar. Remove the feed tube.
Figure 5-27 Removing the Feed Tube
#8-32 Set
Screws (x 2)
5. Remove the four #8-32 screws securing the LNB/feed
tube assembly to the reflector base (see Figure 5-25).
Remove the LNB/feed tube assembly.
6. Disconnect the motor cable from the skew motor.
Figure 5-28 Skew Motor and Belt
Motor Cable
Connector
Motor Hub
7. Using a 2.5 mm allen wrench, remove the four M3 cap
screws and #4 washers securing the motor to the
LNB/feed tube assembly (see Figure 5-28). Remove the
old skew motor.
Feed Tube
Motor Cable
Pulley
Skew Belt
M3 Cap Screws
and #4 Washers
(x 4)
54-0198