How To Use The Remote Controller - Dog trace d–control 620 User Manual

REPROGRAMMING OF YOUR RECEIVER
The receiver can be programmed repeatedly without restraint either using the same remote
controller or with another (see the section Programming /matching/ of your remote controller
and receiver).
ADVICE: It is possible to program an unlimited number of receivers to one transmit-
ter, which is possible to use for training of several dogs at the same time.
It is possible to record two transmitters into one receiver, which can be used,
for instance, for a potential correction of the dog's training by an instructor.

How to use the remote controller

The DOGtrace™ d–control remoter controller is designed for cooperation with two separate
receivers independent of each other.
Button – Sound signal
When you press down the sound signal button, you will be able to send the sound signal to
your receiver at a long distance. There is no time limit for this function: The buzzer will sound
for as long as you are holding the pressed down button and the green LED on your receiver
will be permanently lit.
It will be indicated by the transmission symbol on the LCD display of your remote controller.
Button – Correction impulse
By pressing down this button, you send your dog a warning in the form of an electronic
impulse transmitted by the two electrodes located in the receiving collar. The implulse is
given as long as you keep the button pressed to a maximum of 8 seconds.
The red LED diode on your receiver is lit permanently.
It will be indicated by the transmission symbol on the LCD display of your remote controller.
10