Dog trace d–control 620 User Manual page 7

INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE REMOTE CONTROLLER
Remove the cover of the battery compartement and insert 2 LR6 alcaline batteries.
Mind the correct polarity marked in the battery compartement.
Replace the cover and tighten the screw.
Checking the battery status
Look at the LCD display to check the battery status:
Fully charged battery: full battery symbol shines in the LCD permanently in on state.
Weak battery: LCD display indicates battery capacity decrease. In case the battery symbol
is empty, insert new LR6 batteries according to the instructions above.
Make sure that the receiver works correctly.
NOTICE: you can also use rechargeable batteries in the remote controller.
They do not provide enough voltage for correct battery status indication
on the LCD.
CAUTION: Always switch off the remote controller before battery removal,
remove the battery and shortcut battery contacts using a metal tool.
7