Operation Procedure - Sharp DW-R268A Operation Manual

Operation Procedure

AUTO DEHUMIDIFY operation
(Indication example)
AUTO DEHUMIDIFY mode, slightly high humidity, WIDE SWING louver in air flow direction "Up".
Lighting
1
Press the POWER ON/OFF button.
The OPERATION indicator lights and AUTO DEHUMIDIFY operation starts.
With the start of operation, the WIDE SWING louver rotates
from "Close" to "Up" and stops in that position.
2
PresstheAUTODEHUMI D I F Ybuttonandsel e ctoperati o nmode.
Operation mode is switched in order.
AUTO
PREVENT
CONDENSATION
Caution
MOLD ATTACK
3
Set the direction of the WIDE SWING louver.
Choose the optimum setting.
Press the POWER ON/OFF button again.
Stop
When operation stops, the WIDE SWING louver returns to "Close" position. Note that in stopped
condition, the humidity is not indicated.
* If the POWER ON/OFF button is pressed to restart the unit after a stop, the unit resumes
operation in the previous selected mode.
WIDE SWING button AUTO DEHUMIDIFY button
Lighting
3
The unit stops dehumidifying and blows air only when
the humidity is about less than 60% at temperatures up
to 27¡C, and when the humidity is about less than 55%
at temperatures of 28¡C or higher.
However, depending on the room size and construction,
the unit may not stop dehumidifying.
DEHUMIDIFY operation is continuously carried out by
controlling the volume of air flow: ÒMediumÓ at temperature
of about 15¡C or more and ÒHIGHÓ at about 15¡C or less.
Under the following conditions, PREVENT CONDENSATION operation
will stop and the unit will change to fan operation. (See figure at right.)
The room temperature is 35¡C or more and humidity is less than 40%.
The room temperature is above 28¡C and less than 35¡C, and
humidity is less than 30%.
To prevent the formation of mold, use the unit in rooms where
mold tends to form such as rooms on the north side or store
rooms where people are normally not present.
When humidity drops to below 50%, the dehumidifying
operation stops and the unit changes to fan operation.
page
Lighting
2
WIDE SWING louver
CLOSE
(Right figure)
POWER ON/OFF button
Lighting
OPERATION
indicator
1
UP
DEHUMIDIFY AUTO
operating range
Temperature ¡C
DEHUMIDIFY
operating range
Temperature ¡C
E-9