How To Operate The Timer - Sharp DW-R268A Operation Manual

How to Operate the Timer

To set on timer
Confirm that the OPERATION indicator has gone out and operation has stopped.
Press the TIMER button.
1
The ON TIMER indicator, [
TIMER SETTING indicator light. At the same time, the
indicator for the previously selected mode lights.
When the POWER ON/OFF button is pressed after the
power plug has been plugged in, or when the POWER ON /
OFF button is pressed after a power outage, the unit is
preset to start operation in AUTO DEHUMIDIFY mode.
When the TIMER button is kept pressed, the indication on the
LED display changes automatically. While pressing the TIMER
button, the timer setting time changes as shown below in
1-hour increments. Select the setting time.
Select the desired operating mode.
2
Select the desired operating mode by pressing the AUTO DEHUMIDIFY button, CONTINUOUS
DEHUMIDIFY button or DRY CLOTHES button.
The following settings can be changed as desired.
When AUTO DEHUMIDIFY is selected, the DEHUMIDIFY mode can be changed by pressing the AUTO DEHUMIDIFY button.
When CONTINUOUS DEHUMIDIFY or DRY CLOTHES is selected, the air flow mode can be
selected with the respective selector button.
Pressing the WIDE SWING button lets you select the air flow direction from the WIDE SWING louver.
Pressing the PLASMACLUSTER button turns PLASMACLUSTER ION operation on and off.
If you set ON TIMER operation as Òafter 5 hoursÓ
Example
The timer indication changes every hour from 5
When the TANK FULL indicator blinks, empty the drain tank.
Caution
The operating mode can be changed even after ON TIMER operation has been selected.
To change the mode, press the respective operation button.
Canceling ON TIMER operation
To release timer operation, either press the TIMER button until the ON TIMER and TIMER SETTING indicators
go off or press the POWER ON/OFF button.
It can be set only when the unit is shut down.
] on the LED display and the
No indication
(set release)
4 3
TIMER SETTING
TIMER ON
indicator
indicator
Lighting
1
TIMER SETTING
button
page
2 1, and after 5 hours operation starts.
Lighting
page
page
page
E-13