Guide Stop - Gerima SMA 50?E1 Operating Manual

Guide stop
The guide stop is used when milling bevels at an
angel in the range 0°–80°on straight workpiece
edges
1
2
3
4
1 Retaining bracket
2 Fixed retaining screw
3 Hardened stopping plates
4 Chip protector
5 Cutouts for fixing chip collector pan
6 Fastening screws for the stopping plates
7 Adjuster screw
8 Slot for distance adjustment
9
10
9 Wing bolts
10 Chip collector pan
Guide stop with chip collector pan attached
Guide stop
8
7
6
5
Guide stop is simply and easily mounted on the
guide plate.
Fixed retaining
screw
The guide stop, which replaces the guide bearing, has to
be fitted when the machine is used to mill a bevel on a
straight workpiece that will leave only a small base or
no base on the end face (see page 12). When the guide
stop is fitted, the bevel width is also set by adjusting the
height of the guide plate.
The guide stop is also useful when machining the end
face only (0° bevel) as it allows precise adjustment of
the amount of material being removed.
When machining very small bevels with the guide stop
fitted and with the height of the guide plate accurately
adjusted, the cutting inserts can be indexed multiple
times allowing the full length of the cutting edges to be
used.
34
V.02 .22.03.10.ENG
Adjuster screw