Gerima SMA 50?E1 Operating Manual page 33

Attaching the adapter:
1. Loosen the four countersunk head screws
on the guide‐plate and remove it from the
adjuster ring. Place the 20‐mm spacer ring
on the adjuster ring and secure it by tighten‐
ing the four screws. Now fasten the guide‐
plate unit onto the spacer ring.
2. Loosen the screws at the side of the guide
plate unit and lift it off from the gear hous‐
ing.
3. Place the adapter into the hexagonal socket
that forms part of the drive shaft and fasten
by means of the two hex socket cap screws.
To ensure a safe and secure fitting, use a
medium‐strength thread locking sealant
when tightening the screws.
4. Once the adapter has been fitted, place the
milling head with the M14x1 threaded
mount into position and tighten using the
two hook spanners. Insert the required
guide bearing through the milling head and
screw it tightly to the adapter.
5. Replace the guide plate unit onto the gear
housing and screw it tight.
6. Release the clamping screw and adjust the
guide plate to the required height.
Important!
To disassemble, perform steps in reverse
order. Please note that the guide bearing
must be loosened first before attempting to
remove the milling head with the hook
spanners.
Do not use the spindle locking button!
This is not designed for these types of
loads.
Accessories: Adapter
Always disconnect from the power supply before
working on the machine!
CAUTION
Do not lock
spindle!
1
2
3
33
4
5
6
V.02 .22.03.10.ENG