Gerima SMA 50?E1 Operating Manual page 20

Indexable cutting inserts for radius milling
Adjusting the radii:
Please note that only the position of the upper
edge of the radius can be adjusted by rotating
the guide plate. The lateral position of the radius
on the workpiece end face is determined by the
guide bearing fitted and cannot be altered.
Guide plate set too low
(Radius incomplete)
Guide plate set too high
(Radius cuts into material)
Guide plate set correctly
(Radius fully formed with smooth transition to
workpiece surfaces)
too low
too high
correct
20
V.02 .22.03.10.ENG