8. GERIMA spare parts
Standard
DL= large
Alternative
DS= small
Accessories: RM 2
Milling head MH‐45/R2‐A43.1
Can be combined with a DL‐45/R2‐A43‐1 guide
bearing and fitted with type M indexable cutting
inserts for milling 45° bevels, or fitted with RM 2
radius‐milling inserts for milling 2 mm radii.
45° bevel, large guide bearing DL
Combining the large DL‐45/R3‐A43.1 guide bear‐
≤ 5 mm = 8‐fold
ing with type M indexable cutting inserts, en‐
> 5 mm = 4‐fold
ables the inserts to be indexed a total of eight
times if the bevel widths being machined are
≤ 5 mm, or indexed four times if the bevel
widths are > 5 mm.
Or
RM 2 = 8‐fold
Radius: 2.0 mm
The same DL guide bearing is used with the
eight‐fold indexable RM 2 radius‐milling inserts.
1 ‐ 10 mm = 4‐fold
45° bevel, small guide bearing DS
If the small DS‐45/R2‐A43.1 guide bearing is
combined with type M indexable cutting inserts,
the inserts can be indexed four times if the bevel
being machined is between 1 and 10 mm wide.
RM 2 = 4‐fold
Or
Radius: 2.0 mm
The same DS guide bearing is chosen when the
RM 2 radius‐milling inserts are used for milling
tight contours or smaller diameter drill holes. In
this case the inserts can be indexed a total of
four times.
28
V.02 .22.03.10.ENG