Adapter SK21.9 / M14
An adapter is required if special milling heads or
milling heads with a M14x1 threaded mount are
to be used with the machine. The hexagonal
adapter post is pushed into the socket that
forms part of the drive shaft and then attached
to the shaft by two hex socket cap screws.
By using the adapter, the former standard mill‐
ing heads with a M14x1 threaded mount are
compatible with the new push‐on connection
system.
In order to adjust the height correctly and to be
able to use the scale when the adapter is fitted,
the 20‐mm spacer ring m ust also be fitted.
1
2
3
4
5
6
Order no. for SK21.9/M14 adapter
with spacer ring 0109.107.09‐00001
Accessories: Adapter
3
6
1
2
3
4
5
6
1 Guide bearing
2 Milling head M14
3 Hex socket cap head screws 6912 ‐
M6 x 10
4 Adapter SK21.9/M14
5 Countersunk‐head screws M5x25
6 Spacer ring 20 mm
Hooks spanners must be used to assemble and
disassemble the milling head.
See page 33
32
V.02 .22.03.10.ENG