Gerima SMA 50?E1 Operating Manual page 30

Standard
DL= large
Accessories: RL 6
Milling head MH‐R6‐A45.1
fitted with a DL‐R6‐A45.1 guide bearing and RL 6
radius‐milling inserts for cutting 6 mm radii.
Radius: 6.0 mm
RL 6 = 8‐fold
DL‐R6‐A45.1 guide bearing used with the eight‐
fold indexable RL 6 radius‐milling inserts
Radius 6 mm
Fitting instructions:
The alignment disc is used to centre the fitting
bolt and for the exact positioning of the radius‐
milling inserts.
Start by mounting the DL guide bearing with the
alignment disc onto the milling head. Then fasten
each of the RL8 cutting inserts to the milling head
via locating hole (1) taking care to press each in‐
sert against the alignment disc RS8 as it is tighte‐
ned down. This ensures that the radius‐milling
inserts are exactly and accurately aligned.
30
Alignment disc RS 6
V.02 .22.03.10.ENG