Gerima SMA 50?E1 Operating Manual page 29

Standard
DL= large
Milling head fitted with RK 4 cutting inserts and
RP 4 alignment plates.
Accessories: RK 4
Milling head MH‐45‐R4‐A44.1
fitted with a DL‐R4‐A44.1 guide bearing and RK 4
radius‐milling inserts for cutting 4 mm radii.
Radius: 4.0 mm
RK 4 = 8‐fold
DL‐R4‐44.1 guide bearing used with the eight‐
fold indexable RK 4 radius‐milling inserts.
Radius 4 mm
Fitting instructions:
First attach the alignment plates to the milling
head by screwing them into locating hole (2) so
that they alignment plates are centred but not
screwed down tightly. Then fasten each of the
RK 4 cutting inserts to the milling head via locat‐
ing hole (1) taking care to press each insert
against its alignment plate as it is tightened
down. Finally, screw the alignment plates tightly
into place.
29
RP 4 alignment plate
V.02 .22.03.10.ENG