6. Maintenance
Before changing the cutting tools or servicing
the machine, always disconnect the machine
from the power supply by removing the power
cable from the socket.
Hot cutting inserts and milling head!
• Burn hazard!
• Wear protective gloves when changing the
milling head.
2
1
Maintenance plan
Part to be serviced
Type of maintenance
work
Re‐grease every 1000
1
Mitre gear
operating hours
Clean as required
2
Ventilation slots
Replace as necessary
3
Carbon brushes
Height‐adjuster
Clean and lubricate as
4
thread
necessary
Indexable cutting
Rotate or replace as neces‐
inserts
sary
Maintenance
2
3
4
Servicing to be
carried out by
certified GERIMA
service agent
Machine operator
Electrical technician
Trained technician
Machine operator
Blunt tools can cause damage!
• Blunt cutting tools can overload the machine.
• Inspect cutting tools regularly for signs of wear.
• Wear protective gloves when replacing or read‐
justing the indexable cutting inserts.
Improperly repaired machines are a hazard!
• Increased risk of injury!
• Machine does not function correctly.
Repairs must only be carried out by a GERIMA‐
trained technician.
Maintenance procedure
Disassemble milling head
see page 25
Clean ventilation slots
See page 25
Disassemble guide plate unit
see page 25
See page 27
24
V.02 .22.03.10.ENG
Materials
Order no.
required
Lubricating
0101.204.04‐00018
grease
Brush, cloth,
compressed
air
Set of carbon
0101.323.07‐00007
brushes
Teflon spray
0901.100.04‐00010
See page 37 + 38