Standard
DL= large
Accessories: RL 8
RL 8 = 4‐fold
31
Milling head MH‐R8‐A45.1
fitted with a DL‐R8‐A45.1 guide bearing and RL 8
radius‐milling inserts for cutting 8 mm radii.
Radius: 8.0 mm
DL‐R8‐A45.1 guide bearing used with the four‐
fold indexable RL 8 radius‐milling inserts.
Radius 8 mm
Fitting instructions:
The alignment disc is used to centre the fitting
bolt and for the exact positioning of the radius‐
milling inserts.
Start by mounting the DL guide bearing with the
alignment disc onto the milling head. Then fas‐
ten each of the RL8 cutting inserts to the milling
head via locating hole (1) taking care to press
each insert against the alignment disc RS8 as it is
tightened down. This ensures that the radius‐
milling inserts are exactly and accurately aligned.
V.02 .22.03.10.ENG
Alignment disc RS 8