Table of Contents
Advertisement
3. HARDWARE SETUP
3.10 Starting Up the First Time
1. After you have made all the connections, replace the system unit cover.
2. Be sure that all switches are off (in some systems, marked with ), and the
power input voltage is set to comply with the standard used in your country
(220V-240V or 110-120V).
3. Connect the power supply cord into the power supply located at the back of
your system unit according to the system user's manual.
4. Connect the power cord into a power outlet that is equipped with a surge protector.
5. You may then turn on your devices in the following order:
a. Your monitor
b. External SCSI devices (starting with the last device on the chain)
c. Your system power. For ATX power supplies, you need to switch on the
power supply as well as press the ATX power switch on the front of the case.
6. The power LED on the front panel of the system case will light. For ATX power
supplies, the system LED will light when the ATX power switch is pressed. The
LED on the monitor may light up or switch between orange and green after the
system's if it complies with "green" standards or if it has a power standby feature.
The system then runs power-on tests. While the tests are running, the BIOS
alarm beeps or additional messages appear on the screen. If you do not see
anything within 30 seconds from the time you turn on the power, the system
may have failed a power-on test. Re-check your jumper settings and connections
or call your retailer for assistance.
Award BIOS Beep Codes
Beep
One short beep when
displaying logo
Long beeps in an endless loop
One long beep followed by
three short beeps
High frequency beeps when
system is working
34
Meaning
No error during POST
No DRAM installed or detected
Video card not found or video card
memory bad
CPU overheated
System running at a lower frequency
D1260 CUR-DLSR User's Manual
Advertisement
Table of Contents
