Fujitsu Siemens Computers D1260 User Manual page 36

3. HARDWARE SETUP
28) Chassis Open Alarm Lead Connector
This connector is designed for chassis intrusion detection. When any chassis
component is removed, the contact should open and the motherboard will record
a chassis intrusion event. The event can be processed by software such as LDCM.
CUR-DLSR Chassis Open Alarm Lead
29) ATX Power Connector (20/24-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power supply
will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT: Make sure that your ATX power supply can supply at least 720mA
on the +5-volt standby lead (+5VSB). You may experience difficulty in turning
ON your system if your power supply cannot support the load.
CUR-DLSR ATX Power Connector
30
CUR-DLSR
CUR-DLSR
D1260 CUR-DLSR User's Manual
1 3 4
CHASSIS
1