Fujitsu Siemens Computers D1260 User Manual page 30

3. HARDWARE SETUP
10) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as the
PCI-L101 Ethernet card (see 7. APPENDIX). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.
IMPORTANT: This feature requires that Wake On LAN is enabled (see 4.5.1
Power Up Control) and that your system has an ATX power supply with at least
720mA +5V standby power.
CUR-DLSR Wake-On-LAN Connector
11) Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that PCI Modem card is enabled (see
4.5.1 Power Up Control) and that your system has an ATX power supply with at
least 720mA +5V standby power.
CUR-DLSR Wake-On-Ring Connector
24
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
+5 Volt Standby PME
CUR-DLSR
Ground
CUR-DLSR
D1260 CUR-DLSR User's Manual
WOL_CON
Ground
WOR
1 2
Ring#