Primary & Secondary Master/Slave - Fujitsu Siemens Computers D1260 User Manual

4.3.1 Primary & Secondary Master/Slave
...
Main
Primary Master [Auto]
Type
Cylinders
Head
Sector
CHS Capacity
Maximum LBA Capacity
Multi-Sector Transfers
Smart Monitoring
PIO Mode
Ultra DMA Mode
F1 Help ↑↓ Select Item
ESC Exit ←→ Select Menu
NOTE: Before attempting to configure a hard disk drive, make sure you have the configuration
information supplied by the manufacturer of the drive. Incorrect settings may cause your system to
not recognize the installed hard disk. To allow the BIOS to detect the drive type automatically, select
[Auto].
Type [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic detection is successful, the
correct values will be filled in for the remaining fields on this sub-menu. If automatic detection fails,
your hard disk drive may be too old or too new. You can try updating your BIOS or enter the IDE
hard disk drive parameters manually.
NOTE: After the IDE hard disk drive information has been entered into BIOS, new IDE hard disk
drives must be partitioned (such as with FDISK) and then formatted before data can be read from
and write on. Primary IDE hard disk drives must have its partition set to active (also possible with
FDISK).
Other options for the Type field are:
[None] - to disable IDE devices
4. BIOS SETUP
[Auto)
[ 1026]
[255]
[63]
84228MB
25598MB
[Maximum]
[Disabled]
[4]
[2]
-/+ Change Values
Enter Select Ê Submenu
D1260 CUR-DLSR User's Manual
Item Specific Help
F5 Setup Defaults
F10 Save and Exit
43