Fujitsu Siemens Computers D1260 User Manual page 33

3. HARDWARE SETUP
18) ATX Power Switch / Soft-Off Switch Lead (2-pin)
The system power is controlled by a momentary switch connected to this lead.
Pushing the button once switches the system between ON and SLEEP or ON
and SOFT OFF, depending on your BIOS or OS setting. Pushing the switch
while in the ON mode for more than 4 seconds turns the system off. The system
power LED shows the status of the system power.
19) Reset Switch Lead (2-pin)
This 2-pin connector connects to the case-mounted reset switch for rebooting
your computer without having to turn off your power switch. This is a preferred
method of rebooting to prolong the life of the system power supply.
20) System Power LED Lead (3-1 pin)
This 3-1 pin connector connects to the system power LED that lights up when
the system is powered on and blinks when it is in sleep or soft-off mode. This
feature can be programmed through the ASIC.
21) NMI Button (2-pin)
This 2-pin connector connects to a panel button to allow a non-mask interrupt
command to be sent to the operating system.
22) System Warning Speaker Connector (4-pin)
This 4-pin connector connects to the case-mounted speaker.
23) IDE Activity LED (2-pin)
This connector supplies power to the IDE activity LED. Read and write activity
by devices connected to the Primary or Secondary IDE connectors will cause
the LED to light up.
D1260 CUR-DLSR User's Manual 27