Fujitsu Siemens Computers D1260 User Manual page 28

3. HARDWARE SETUP
6) Serial Port (Teal/Turquoise 9-pin COM1)
The serial port can be used for pointing devices or other serial devices. See
Onboard Serial Port 1 in 4.4.2 I/O Device Configuration for settings.
7) Monitor Output Port (Blue 15-pin VGA)
This connector is for output to a VGA-compatible device.
8) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connecting
the single end to the board, connect the two plugs on the other end to the floppy
drives. (Pin 5 is removed to prevent inserting in the wrong orientation when
using ribbon cables with pin 5 plugged).
CUR-DLSR Floppy Disk Drive Connector
22
COM1
Serial Ports (9-pin Male)
VGA Monitor (15-pin female)
CUR-DLSR
D1260 CUR-DLSR User's Manual
PIN 1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.