Table of Contents
Advertisement
IMPORTANT: If your hard disk was already formatted on an older previous system, incorrect
parameters may be detected. You will need to enter the correct parameters manually or use low-
level format if you do not need the data stored on the hard disk. If the parameters listed differ from
the ones used when the disk was formatted, the disk will not be readable. If the auto-detected
parameters do not match the ones that should be used for your disk, you should enter the correct
ones manually by setting [User Type HDD].
...
Main
Primary Master [User Type HCC]
Type
Translation Method
Cylinders
Head
Sector
CHS Capacity
Maximum LBA Capacity
Multi-Sector Transfers
SMART Monitoring
PIO Mode
Ultra DMA Mode
F1
Help
↑↓
Select Item
ESC Exit
←→
Select Menu
[User Type HDD]
Manually enter the number of cylinders, heads and sectors per track for your drive. Refer to your
drive documentation or look on the drive for this information. If no drive is installed or if you are
removing a drive and not replacing it, select [None].
Translation Method [LBA]
Select the hard disk drive type in this field. When Logical Block Addressing is enabled, 28-bit
addressing of the hard drive is used without regard for cylinders, heads, or sectors. Note that LBA
Mode is necessary for drives with greater than 504MB in storage capacity. Configuration options:
[LBA] [LARGE] [Normal] [Match Partition Table] [Manual]
Cylinders
This field configures the number of cylinders. Refer to your drive documentation to determine the
correct value to enter into this field. NOTE: To make changes to this field, the Type field must be set
to [User Type HDD] and the Translation Method field must be set to [Manual].
44
4. BIOS SETUP
[User Type]
[LBA]
[ 1024]
[255]
[63]
84228MB
25598MB
[Maximum]
[Disabled]
[6]
[2]
-/+
Change Values
Enter Select Ê Submenu
D1260 CUR-DLSR User's Manual
F5 Setup Defaults
F10 Save and Exit
Advertisement
Table of Contents
