Unpacking And Installation; Setting Up; Removing The; Unpacking And Installing The Outdoor Unit - Danfoss DHP-H Installation And Service Instructions Manual

5

Unpacking and installation

5.1

Setting up

• The heat pump has feet that can be adjusted 20 mm to compen-
sate for irregularities in the surface on which it is sitting. If the
surface is so irregular that the feet cannot compensate for it, the
installation engineer must remedy this.
• It is recommended that a condensation drain be installed from
the drain pipe of the drip tray while the heat pump is on its side.
The drain pipe opens through a hole in the base plate and has a
Ø 10 mm hose connection.
1. Move the heat pump to the installation site. If there is little
space the heat pump can be separated according to the section
"Separating the heat pump".
2. Remove the packaging.
Figure 31: Condensation drain connection
3. Install a condensation drain on the connection in the base plate
if required.
4. Set up the heat pump in the installation site.
Figure 32:
5. Adjust the feet so that it is horizontal.
5.2 Removing the front cover
⚠ NOTE! Do not damage the electrical wiring for the control
computer when the front cover is removed!
To install the heat pump the front cover must be removed.
2
3
Figure 33: Removing the front cover.
1. Hold the front panel with one hand and turn the catch 90° anti-
clockwise to detach the front panel.
22
Adjusting the feet.
1
2. Tilt the front cover outwards.
3. Lift the front cover upwards to remove it from the heat pump.
5.3 Unpacking and installing the outdoor
unit
Applies to DHP-A, -AL.
The outdoor unit is packed and delivered in a crate.
1. Start by unpacking the unit from the crate.
2. Check that the delivery is complete, it must contain the out-
door unit, front cover, cover as well as a disassembled stand
including necessary screws, nuts and washers.
Assembling the stand
1. Screw the two horizontal struts together (1) using the two ends
(2) as illustrated below. Use 8 x M6x10 screws. The curved edges
of the horizontal struts must be facing upwards and inwards.
Bent edge
2
Slit
3
Figure 34:
2. Screw the adjustable feet (3) into the holes under the ends.
Preparing the outdoor unit
While the outdoor section remains on the pallet it should be pre-
pared for placing on the stand. Carry out the following:
3. There are three M6x20 screws on the lower edge of the outdoor
unit. Unscrew them so that 2-3 mm of the thread remains. Use a
torx TX25 screwdriver, or equivalent.
4. Raise the outdoor unit. NOTE! Do not lift the side plates.
5. Remove the side plates. They are held in place by clamps and
so are removed by pulling outwards.
6. Remove all four screwed lifting eyes. Use a 13 mm wrench, or
equivalent.
Assembling the outdoor unit on the stand
7. Lift the outdoor unit into the place on the stand.
Figure 35:
VMBMA602
1
1
3
Assembling the stand.
Lift the outdoor unit onto the stand.
2
Slit