Unpacking And Installation; Setting Up; Removing The; Unpacking And Installing The Outdoor Unit - Danfoss DHP-AL Installation And Service Instructions Manual

4

Unpacking and installation

4.1

Setting up

Both the heat pump and water heater are prepared to be connected
together, either to the left or right of each other.
When setting up the heat pump and water heater, the heat pump
must be placed in the direction of where the brine pipes are to be
connected. The water heater should then be placed on the oppo-
site side and should be positioned next to the heat pump.
The heat pump and water heater have feet that can be adjusted
20 mm to compensate for irregularities in the surface on which
they are sitting. If the surface is so irregular that the feet cannot
compensate for it, the installation engineer must remedy this.
It is recommended that a condensation drain be installed from
the drain pipe of the drip tray while the heat pump is on its side.
The drain pipe opens through a hole in the base plate and has a
Ø 10 mm hose connection.
1. Move the heat pump and water heater to the installation site.
2. Remove the packaging.
Figure 11: Condensation drain connection
3. Install a condensation drain if required.
Figure 12: Adjusting the heat pump.
4. Set up the heat pump and water heater in the installation site.
5. Adjust the feet (1) so that they are horizontal.
10
4.2 Removing the front cover
⚠
NOTE! Do not damage the electrical wiring for the control
system when the front cover is removed!
To install the heat pump and water heater, the front covers must be
removed.
Figure 13: Removing the front cover.
1 Unscrew the screws (3).
2 Slide the front cover (2) upwards and carefully lift it off upwards
and forwards.
3 Place the front cover next to the heat pump.
4.3 Unpacking and installing the outdoor
unit
The outdoor unit is packed and delivered in a wooden crate.
1 Start by unpacking the unit from the wooden crate.
2 Check that the delivery is complete, it must contain the outdoor
unit, front cover, cover as well as a package containing the disas-
sembled stand including necessary screws, nuts and washers.
2
Figure 14: Assembling the stand.
3 Screw the two horizontal struts together (1) using the two ends
(2). The curved edge of the horizontal struts must be facing
upwards. Screws and washers for installation are supplied.
4 Press the adjustable feet (3) into the holes under the ends.
5 There are two pre-drilled holes in the bottom plate of the out-
door unit where the stand is screwed into place with 2 screws
per side.
VMBME102
1
2
3