Table of Contents
Advertisement
5
Unpacking and installation
The heat pump is packed in boxes and wrapped in cardboard and delivered on a wood pallet.
1.
Check that the delivery is complete and undamaged.
Caution! When moving the heat pump, do not use the protruding pipe connections to lift the heat pump.
The packaging should not be used to lift the heat pump either.
5.1
Setting up
1.
Move the heat pump to the installation site.
2.
Cut off the straps and remove the packaging.
3.
Lift the heat pump from the pallet.
4.
Install a condensation drain if required.
1
Figure 11.
Make sure that the heat pump is level
using a spirit level
5.
Adjust using the adjustable legs (1) so that the heat pump stands upright and level on the floor.
5.2
Removing the front cover
Remove the front cover plate as follows:
1.
Unscrew the screws (1).
2.
Slide the front cover (2) upwards and carefully lift it off upwards and forwards.
3.
Place the front cover next to the heat pump.
14 – Installation instructions VMIFJ102
Symbol explanation
1
Adjustable feet
Advertisement
Table of Contents
