Transport, Unpacking And Setting-Up; Transporting The Heat Pump; Setting-Up The Heat Pump - Danfoss DHP-M Installation Manual

Installation Guide
3

Transport, unpacking and setting-up

3.1

Transporting the heat pump

Caution
Caution
3.1.1 Unpacking
1. Check that there are no transportation damages.
2. Remove the packaging.
3.1.2 Delivery check
Check that the delivery includes the following items:
Name
Heat pump
Document set
Sound plate kit, 086L3375
Name
Front and rear plate
Left and right side plate
Sensor kit, 086L3546 (in the electrical cabinet)
Name
Outdoor sensor
System supply line sensor
3.2

Setting-up the heat pump

3.2.1 Recommended location
Positioning the heat pump
▪ The heat pump should preferably be placed against an outside wall (see chapter 'Heat pump data')
▪ Do not place the heat pump against walls facing noise-sensitive areas.
▪ Avoid placing the heat pump in the corner of a room.
10
DHP-M
The heat pump must always be transported and stored upright in a
dry environment. Secure the heat pump so that it cannot tip over dur-
ing transportation.
If the heat pump is laid on the incorrect side it may become seriously
damaged, as the oil in the compressor may run out into the pressure
pipe and thereby prevent normal functioning.
Quantity
1
1
Article number
086L3376
086L3377
Article number
086U3351
086L3356
VMJSB202
Quantity
2
2
Quantity
1
1
Danfoss Heating Solutions