Preparing The Wall Mounting - Fronius IG 2000 Operating Instructions Manual

Preparing the The following describes how the FRONIUS IG is mounted to the wall. As
your FRONIUS IG is delivered, the mounting plate is fixed to the inverter
wall mounting
by two screws on the bottom of the FRONIUS IG.
For mounting the inverter to the wall proceed as follows:
- Loosen the screws (1) on the bottom of the inverter and remove the
- Fix the mounting plate (2) to the wall using four suitable screw anchors
In most cases, you should use 1/4 in. or 5/16 in. stainless steel or alumini-
um screws capable of supporting 26 lbs (FRONIUS IG 2000, 3000 and
2500-LV) or 42 lbs (FRONIUS IG 4000, 5100 and 4500-LV) of inverter
weight. Triangulate the positions of these on the mounting plate using the
pre-drilled holes when possible. Three vertically aligned holes for single
stud mounting will suit most installations.
- Slide the FRONIUS IG from above so that the unit may hang from the
- Attach the FRONIUS IG to the bottom of the mounting plate (2) by
mounting plate (2)
(3) and screws (4)
(4) (3)
(4)
(4) (3)
(4) (3)
(1)
CAUTION! The FRONIUS IG may become dislodged and fall from
the mounting plate if the unit is not fixed to the mounting plate using
the two screws at the bottom (that were removed at the beginning).
NOTE! If you modify the FRONIUS IG enclosure with custom
openings you will be required to return the unit for repair in the
event of a warranty-related issue rather than doing an inverter
exchange. Knockouts for grounding electrode may be required by
local authorities.
top of the mounting plate (2)
using the screws (1) that were removed before
(2)
(3)
Important! Due to the variety of
screw anchors (3) and screws (4)
available for the various types of
wall surfaces, these are not inclu-
ded.
44