Ground connection
Ground the antenna mast at the Az/El mount by attaching the
ground wire to the elevation lockdown bolt as shown in
Figure 33. For specific grounding procedures, refer to the sources
listed in Grounding on page 5.
Note: Although the radio transmitter contains a ground screw, a
separate ground wire to the radio assembly is not required; the
radio assembly is grounded through the metallic shield of the
coaxial cable.
Figure 33: Ground screw on the Az/El mount
This completes the installation. You must now point the antenna.
See the Ka-Band Antenna Pointing Guide (1037663-0001) for
details.
Chapter 4 • Cabling and connections
1037750-0001 Revision A
41