Table of Contents
Advertisement
Routing the cables at
the antenna
Chapter 4 • Cabling and connections
36
1037750-0001 Revision A
Route the coaxial transmit (Tx) and receive (Rx) cables at the
antenna as follows:
1. Route the Tx cable (marked with blue electrical tape) over the
Az/El mount assembly, down behind the reflector, and along
the feed support arm to the rear of the transmitter, in a
configuration similar to that shown in Figure 29.
Note: Do not exceed the minimum bending radius specified by
the cable manufacturer.
Figure 29: Transmit and receive cable configurations
2. Leave a 10-foot service loop and secure it to either the mast,
Az/El mount, or reflector bracket.
Note:
1. Do not leave the service loop lying on the roof or other
mounting surface.
2. Do not block access to the azimuth and elevation
adjustment nuts on the Az/El mount assembly.
Advertisement
Table of Contents
