Table of Contents
Advertisement
Installing the
reflector bracket
Begin the antenna assembly by attaching the reflector bracket to
the Az/El mount assembly:
1. Loosen the two screws on either side of the Az/El mount
elevation linkage.
2. Clip the hooks near the top of the reflector bracket over the
elevation linkage as shown in Figure 10.
Figure 10: Attaching the reflector bracket to the Az/El mount
3. Align the tabs on the reflector bracket with the two pivot
holes in the sides of the Az/El mount as shown in Figure 11,
and insert two carriage bolts from the inside, out through the
holes.
4. Secure the reflector bracket to the Az/El mount from the
outside with two ½-inch nuts.
Note: Ensure that the carriage bolts are firmly seated before
tightening the nuts.
Chapter 3 • Installing the antenna and radio assembly
1037750-0001 Revision A
19
Advertisement
Table of Contents
