Table of Contents
Advertisement
Feed horn and collar
Related Components
Tri-mast (or other
Chapter 2 • Antenna parts and required tools
12
1037750-0001 Revision A
The feed horn, shown in Figure 8, attaches to the polarizer
waveguide on the radio assembly by way of the two-piece collar.
The feed horn gathers the reflected signal from the antenna
reflector and channels it toward the LNB.
Although the tri-mast is not part of the antenna kit, it is described
antenna mount)
here because it is the most commonly used mounting option for
the AN8-098P Ka-band antenna. As shown in Figure 9, the
tri-mast can be positioned in a number of configurations to adapt
it for mounting onto surfaces of various angles. For other suitable
antenna mounting options, see the HughesNet Antenna Site
Preparation and Mount Installation Guide (1035678-0001).
Figure 8: Feed horn and collar
NOTICE
• Do not remove the protective packing material from
the feed horn window until installation of the radio assembly
is complete.
• Do not attempt to remove the feed horn window at
any time.
• Be careful not to damage the feed horn window.
Do not touch the plastic film.
Advertisement
Table of Contents
