Table of Contents
Advertisement
3. Coil the extra cable, leave a drip loop, and secure the Tx
cable with cable ties.
4. Route the Rx cable (marked with red electrical tape) over the
Az/El mount assembly, down behind the reflector, and along
the feed support arm to the LNB, in a configuration similar to
that shown in Figure 29 above.
Note: Do not exceed the minimum bending radius specified by
the cable manufacturer.
5. Leave a 10-foot service loop and secure it to either the mast,
Az/El mount assembly, or reflector bracket.
Note:
1. Do not leave the service loop lying on the roof or other
mounting surface.
2. Do not block access to the adjustment nuts on the Az/El
mount assembly.
6. Coil the extra cable, leave a drip loop, and secure the Rx
cable with cable ties.
Chapter 4 • Cabling and connections
1037750-0001 Revision A
37
Advertisement
Table of Contents
