Table of Contents
Advertisement
Chapter 3 • Installing the antenna and radio assembly
22
1037750-0001 Revision A
2. Align the mounting holes in the reflector with the holes in the
reflector bracket as shown in Figure 14.
Figure 14: Attaching the antenna reflector
3. Insert four thread-cutting bolts (½-inch × 3/ 4-inch) into the
holes in the reflector bracket from the back, and through the
corresponding holes in rear of the reflector.
4. Once the reflector is in place, tighten the nuts lightly, only
until snug, then tighten the four bolts that secure the adapter
block to the reflector bracket.
Advertisement
Table of Contents
