Table of Contents
Advertisement
Installing the
feed support arm
and support rods
Figure 15: Attaching the feed support arm to the adapter block
To attach the feed support arm and support rods:
1. Position the feed support arm underneath the adapter block as
shown in Figure 15.
2. Insert a single 7/16-inch × 1
and flat washer, up through the feed support arm from below
and into the threaded socket of the adapter block.
Note: There are two holes near the end of the feed support
arm. Be sure to insert the bolt through the hole that is furthest
from the end, as shown in
3. Tighten until secure.
4. Attach the two support rods to the reflector rim on opposite
sides, using one 7/16 x 1-inch hex head bolt for each rod, as
shown in Figure 16. As shown in the figure, the two tips at
the opposite ends of the support rods are not the same. Be
sure to attach the longer-tipped ends to the reflector, as
illustrated in Figure 16. Do not tighten.
Chapter 3 • Installing the antenna and radio assembly
¾
-inch bolt with lock washer
Figure 15.
1037750-0001 Revision A
23
Advertisement
Table of Contents
