Table of Contents
Advertisement
Installing the antenna
reflector
6. Secure the adapter block in place by inserting four ½ ×
1-inch hex head bolts, with washers, through the holes in the
reflector bracket arm, and into the threaded sockets on the
adapter block (two on each side). Do not tighten the bolts at
this time.
To attach the antenna reflector to the reflector bracket:
1. Place the reflector in position on the reflector bracket so that
the two keys on the bottom of the reflector fit into the
corresponding notches on the adapter block as shown in
Figure 13.
Figure 13: Aligning the reflector with the adapter block
Chapter 3 • Installing the antenna and radio assembly
1037750-0001 Revision A
21
Advertisement
Table of Contents
