Table of Contents
Advertisement
Routing the cables at
the antenna
Chapter 4 • Cabling and connections
30
1037751-0001 Revision A
Route the coaxial Tx and Rx cables at the antenna as follows:
1. Route the Tx cable (marked with blue electrical tape) over the
az/el mount assembly, down behind the reflector, and along
the feed support arms to the rear of the transmitter, in a
configuration similar to that shown in Figure 23.
Note: Do not exceed the minimum bending radius specified by
the cable manufacturer.
Figure 23: Transmit and receive cable configurations
2. Leave a 10-foot service loop secured to the mast, Az/El
mount assembly, or reflector bracket.
Note:
1. Do not leave the service loop on the roof or other mounting
surface.
2. Do not block access to the adjustment nuts on the Az/El
mount assembly.
3. Coil the extra cable, leave a drip loop, and secure the Tx
cable with cable ties.
Advertisement
Table of Contents
