Attaching The Shroud - Hughes DW 3000 One-Way Installation Manual

ATTACHING THE SHROUD

PARTS NEEDED
• Shroud
The shroud helps protect the feed assembly and improves its
appearance. Note that one side of the shroud is wider than the
other. You place the wider side on the right side of the feed
assembly, as you face the satellite dish. The shroud screws are
pre-installed. Do not remove them.
Before placing the shroud over the feed assembly, be sure the
cables are positioned so that when the shroud is placed it does
not interfere with or cause sharp bends in the cables, especially
at the connectors.
1. Facing the satellite dish, place the shroud over the feed
assembly so that the broad side is on the right. Align the
edge of the shroud with the groove in the feedhorn and
insert it in the groove (see Figure 47). Align the triangular
sections also.
Note: the shroud contains four hole plugs (see see Figure 48). Make
sure all the plugs stay in place and over the holes. Doing so will pre-
vent direct rain and snow from getting into the feed assembly.
2. Tighten all five screws, which are already in position, with a
#2 Phillips-head screwdriver. There are four on the narrow
side and one on the broad side. The final assembly will look
like see Figure 49.
Figure 47
38
TOOLS NEEDED
• #2 Phillips-head screwdriver
Plug
Two round plugs,
on opposite sides
Plug
Figure 48
Figure 49