Table of Contents
Advertisement
Installing the antenna
reflector
Chapter 3 • Installing the antenna and radio assembly
18
1037751-0001 Revision A
3. Attach the tailpiece to the free ends of the two feed support
arms as shown in Figure 10, using four
self-tapping bolts, flat washers, lock washers, and nuts.
Figure 10: Attaching the tailpiece
To attach the antenna reflector to the reflector bracket:
1. Insert a ½-inch x ¾-inch carriage bolt through the top hole on
the reflector as shown in Figure 11, and place a
serrated flange nut on the bolt from the back. Do not tighten
at this time.
Figure 11: Insert first bolt into top hole
-inch x
-inch
5/16
2
-inch
5/16
Advertisement
Table of Contents
