Table of Contents
Advertisement
Installing the Az/El and
reflector bracket
assembly
Follow these steps to install the Az/El and reflector bracket
assembly onto the mast:
1. Before you install the Az/El and reflector bracket assembly
onto the mast pipe, use a bubble level to make sure the mast is
plumb.
Check the mast at two perpendicular locations, as shown in
Figure 14.
Note: The mast must be plumb. The antenna assembly
cannot be adjusted to correct for a mast that is not plumb.
Bubble must be centered
between marks.
Bubble
level
Figure 14: Making sure the mast is plumb
2. Slide the canister of the Az/El and reflector bracket assembly
down onto the mast.
Figure 15 shows the Az/El and reflector bracket assembly on
the mast.
Note: The mast must have an outside diameter of
⁄
3
2-
inches (2.375 inches).
8
Mast
Side view
Chapter 3 • Assembling the antenna
To make sure the mast is
plumb, check with the level
in two positions at right
angles to each other.
Level
Mast
2nd level
position
Top view
T0172005
1037312-0001 Revision A
23
Advertisement
Table of Contents
