Masport Piccolo Installation Instructions Manual page 57

INSTALLATION INSTRUCTIONS
Due to high temperatures the Insert should be located
out of traffic and away from furniture and draperies.
Provide a minimum of 48" (1220 mm) front clearance
to the unit.
This appliance is listed for bedroom installations when
used with a listed millivolt thermostat. Some areas
may have further requirements, check local codes
before installation.
This unit is not approved for installation into a mobile
home.
A hearth is not mandatory, but is recommended for aesthetics and for added safety, and if a hearth is installed
follow the requirements listed below. We recommend a non-combustible hearth which comes out a minimum of
12" (305 mm) in front of this appliance. The Zero Clearance Kit allows for a hearth up to 3" (75 mm) thick above
the base to be installed in front of the unit, the ventilation holes must not be blocked. Note: if the hearth is
built up, the faceplates sides will need to be field trimmed to fit, the insulation behind the faceplate must not be
removed.
a) non-combustible floor board meeting ASTM E-136 or E-108
or CAN 4-S114 or the equivalent, and offering a thermal
resistance (k factor) of 0.45 or greater.
b) suitable materials include but are not limited to:
Wonderboard, Durock, Micor, Hardibacker, Capeboard, etc.
c) 1"(25mm) thickness of brick.
LOCATING YOUR U41/I41 FIREPLACE
Non-Combustible Hearth Material
a) Cross Corner
b) Room Divider
c) Flat on wall
HEARTH
Height (y)
(inches)
3"
2-5/8"
2-1/4"
1-7/8"
1-1/2"
1-1/4"
1"
7/8"
5/8"
1/4"
0"
d) Island
e) Flush with Wall
f) Flat on WallCorner
Non-combustible Hearth
Depth (x)
(mm) (inches) (mm)
76mm 21-3/4" 553mm
67mm 21" 534mm
57mm 20" 508mm
48mm 19" 483mm
38mm 18" 457mm
32mm 17" 432mm
26mm 16" 407mm
22mm 15" 381mm
16mm 13" 330mm
7mm 11" 280mm
0mm 9" 229mm
Page 57