Geneva Direct Vent Rear & Top Exit Venting Information; Combustion And Ventilation Air - Masport Piccolo Installation Instructions Manual

COMBUSTION AND
VENTILATION AIR
The combustion air from this appliance is
drawn from outside the building through the
outer flue.
Extra provision for combustion air inside
the room is not required.
IMPORTANT
Read all instructions carefully before starting
the installation. Failure to follow these
instructions may create a fire or other safety
hazard, and will void the warranty. Be sure to
check the venting and clearance to
combustible requirements. Consult your local
building codes before beginning installation.
The location of the termination cap must
conform to the requirements in the Exterior
Vent Terminal Locations diagram on page 40.
Geneva Direct Vent
Rear & Top Exit
Venting Information
VENTING INSTALLATION
PRECAUTIONS
NOT ALLOWED ARE:
1) Installation of any damaged Direct Vent component
2) Unauthorized modification of the Direct Vent System
3) Installation of any component part not manufactured or approved by
Masport Ltd.
4) Installation other than as instructed by Masport Ltd.
Warning: Always maintain required clearances (air spaces) to
nearby combustibles to prevent a fire hazard. Do not fill air spaces
with insulation.
The minimum clearance requirements between the outer wall of the vent pipe
and nearby combustible surfaces is 40mm. Be sure to check the vent termination
clearance requirements from decks, windows, soffits, gas regulators, air supply
inlets and public walkways as specified in your local building codes.
The gas appliance and vent system must be vented directly to
the outside of the building, and never be attached to a chimney
serving a separate solid fuel or gas-burning appliance.
Each direct vent gas appliance must use its own separate vent system. Common
vent systems are prohibited.
Page 39