Masport Piccolo Installation Instructions Manual page 34

FLUEING INFORMATION FOR NEWPORT/NEWPORT PIER
The Newport/Newport Pier uses the "balanced flue" technology Co Axial system. The inner liner vents products of
combustion to the outside while the outer liner draws outside combustion air into the combustion chamber thereby
eliminating the need to use heated room air for combustion and losing warm room air up the chimney.
Note: These flue pipes must not be connected to any other appliance.
The gas appliance and vent system must be vented directly to the outside of the building, and never be attached
to a chimney serving a separate solid fuel or gas burning appliance. Each direct vent gas appliance must use it's
own separate vent system. Common vent systems are prohibited.
FLUEING ARRANGEMENT - HORIZONTAL TERMINATIONS
Masport Direct Vent System (Flex) Horizontal Terminations Only
These flueing systems, in combination with the Newport/Newport Pier Direct Vent Gas Fireplace, have been tested
and listed as a direct flue heater system by Warnock Hersey. The location of the termination cap must conform to the
requirements in the Vent Terminal Locations diagram.
Masport Direct Vent (Flex) System Termination Kit (Part# 946-513) includes all the parts needed to install the
Newport/Newport Pier with a maximum run of 610mm.
1) 178mm dia. flexible liner (2 ft. length)
2) 100mm dia. flexible liner (2 ft. length)
3) Spring spacers (3)
4) Thimble (2)
5) AstroCap termination cap (1)
6) Screws (12)
7) Tube of Mill Pac (1)
8) Plated screws (8)
9) Screws #8 x 1-1/2" drill point, stainless steel (4)
Notes:
1) Liner sections should be continuous without
any joints or seams.
2) Only Flex pipe purchased from Masport may be
used for Flex installations.
3) Masport Direct Vent System (Flex) is only ap
proved for horizontal terminations.
WARNING
When installing in a possible highwind situation common sence must prevail.
Choose sheltered side of the house.
Page 34
4
2
1
5
3