Faceplate & Trim Installation - Masport Piccolo Installation Instructions Manual

INSTALLATION INSTRUCTIONS
1) Lay the faceplate panels flat, facedown on some-
thing soft so they don't scratch.
2) a) Take the top faceplate and align the holes in
it with the holes in the side panels. Using the
screws provided, attach from the top of the
panel (holes in the top panel are slightly
larger than the holes in the side panel to
facilitate easier installation). See diagram 1.
b) 4"(102mm) Hearth Trim. Attach the Hearth
Trim to the bottom of the faceplate side
panels with the screws provided. See dia-
gram 1.
Hint: Don't tighten the screws down completely at
Diagram 1: Faceplate Assembly
this point, do a trial fit to the unit. Make any neces-
sary adjustments and when it fits properly then
tighten down the screws.
Diagram 2: Trim Assembly
Page 52
FACEPLATE & TRIM INSTALLATION
Trim
Clips
3) Using the trim clips provided, join the left side trim
(with the ON/OFF switch) to the top trim. See
diagram 2. Connect the right side trim to the top
trim.
4) Place the trim on the assembled faceplate panels,
aligning the wire connections from the switches
with the notch on the left side panel.
5) Connect the fan switch wires by taking the black
and red wires with the male ends (in the grey
harness) and connect them with the wire connec-
tors from the fan speed control.
Wires to
On/Off
Switch
For Gas
Connection
Diagram 3
6) Connect the ON/OFF switch wires by taking the
black and red wires with the female ends and
connect them to the ON/OFF switch.
7) Install these wires in the clips on the left faceplate
to ensure they dont touch the insert. See diagram
3.
8) The power cord should be run behind the
faceplate panel from the U31/I31 to electrical outlet
box.
ON/OFF
Switch
Fan Speed
Switch
(Rear View)
Self-adhesive
Wire Clip
Wires to
Fan Switch
Connectors
POWER CORD (3ft)