Masport Piccolo Installation Instructions Manual page 5

11. Assemble the two sides, the base, the back and the top of
the outer steel cabinet. Fix the two fascia support angle
strips under the top of the outer cabinet with their flanges
up, thus forming a channel with the front flange of the
cabinet top. (See Fig. 6). When assembling the sides to
the base, fit a bearer rail at each side to raise the base of
the outer cabinet 25mm above floor level. Slide the
cabinet into the constructed recess. Check that it is
centred between the front studs and that the cabinet is '
squared up'. Secure the outer cabinet to the front studs
through the six holes in the front flanges of the outer
cabinet.
12. Assemble sufficient lengths of flue heat shield (150 mm dia.) so that the flue will extend the necessary height
above the roof line. (See flue instructions).
13. Lower the flue shield down through the roof aperture until it is resting on top of the outer steel case. Check
from below that it is centralised on the hole in the cabinet and flash the shield at roof level.
14. Fasten a seismic restraint bracket on each side of the firebox cabinet.
15. Slide the firebox cabinet into the outer cabinet and secure the seismic restraint brackets to the cabinet flanges.
16. Make the gas connection as detailed in the standard manual.
17. Place the 200mm square plate (with the 108mm diameter hole) over the flue spigot on top of the firebox cabinet
(not the outer cabinet).
18. Assemble the appropriate number of flue lengths and fix flue shield spacers as required (see flue instructions).
Lower the assembled flue down through the heat shield in the usual manner and ensure that it engages with the
flue socket of the heater. Fit the flue cowl.
19. Slide in the top front panel of the firebox cabinet and secure it at each side with a screw.
20. Install the insulating blanket on top of the firebox cabinet (not the outer cabinet).
21. Assemble the bottom louvred panel of the fascia to the fascia upright panels, sandwiching the stiffener plate
between them as shown in Fig. 7, using four screws.
22. Offer this assembly into approximately its final position and attach the wiring looms to the switches as detailed in
23. Fit the fascia, using two screws each side, into the firebox cabinet.
Page 5