Installation Instructions; Listings And Code Approvals; Specifications; General Information - Masport Piccolo Installation Instructions Manual

Hide thumbs Also See for Piccolo:

Owner's manual & installation manual (20 pages)

Instruction manual (24 pages)

Installation instructions (4 pages)

Table of Contents

This gas component has been tested in accordance with National Safety Standards, and has been certified by

Warnock Hersey for installation and operation in the United States and Canada as described in these

Installation and Operating Instructions. This gas component has also been tested in accordance with AG103

and certified in Australia by the Australian Gas Association for installation in Australia, and New Zealand.

Install according to AG 103 and as described in these installation and operating instructions.

Check with your local

building code agency

before you begin

your installation to

ensure compliance

with local codes,

including the need

for "permits" and

follow-up inspections.

If any problems are

encountered

regarding code

approvals, or if you

wish clarification on

any of the

instructions

contained here,

contact your local

dealer.

GENERAL INFORMATION

This kit consists of factory built parts that require

minimal assembly to form the Zero Clearance enclo-

sure for the U31/I31 Gas Insert. The enclosure can

then be fixed into a framed combustible construction,

and a standard

"B-vent" (Australia/New Zealand: an approved twin

skin flue) installed on the assembly for the required

venting (flueing). The insert can be installed later.

The faceplate will normally overlap on top of the

finished wall.Using Kit# 410-905 you can convert the

U31/I31 Gas Insert models into highly efficient heat

producing Zero Clearance Fireplaces.