Finished Facing Notes - Masport Piccolo Installation Instructions Manual

10) Attach the brass trim to the faceplate
by drilling a 1/8" (3mm) hole through
the faceplate using the hole in the
trim as a guide. Fasten the trim to
the faceplate panels using the plated
screws. #10 x1/2". See diagram 6
detail 'C'.
11) Attach the faceplate panels to the
insert body using the 4 remaining
black screws.
See diagram 6 detail 'A'.
Top Deflector
Diagram 7: Slide Top Deflector into brackets.
After Deflector is installed
12) Slide the Top Deflector into the two brackets
under the fireplace body top. Diagram 7.
13) Push the logo plate into the two holes in the bottom left corner of the faceplate.
Note: If ashlip is required for safety clearance (see pg. 5) then attach to stove unit using the 2 lower screw holes on the face of the stove
unit (see diagram 6 detail 'B').
Note: This faceplate with Hearth Trim Assembly replaces the standard Assembly as shown in the U31/I31 Installation Manual.
Install finished facing surface of 1/2"(13mm) thickness on framing. Drywall 1/2" (13 mm) thick can extend flush
with the appliance on all three sides of the front face. The height at which the mantel must be installed above
the top louver depends on the depth of the mantel. If the mantel is to be painted, use a heat resistant paint to
prevent discolouration.
INSTALLATION INSTRUCTIONS

FINISHED FACING NOTES

Diagram 6
Page 53